From: 22Cent@gmail.com
Date: Mon May 16 2005 - 10:31:59 GMT-3
Thanks Mani !
On 5/16/05, mani poopal <mani_ccie@yahoo.com> wrote:
> Hi Ray,
>
> You cannot influence the distance on a neighbor by configuring your router.
> But you can go to that neighbor router and change the distance. AD only
> affecting locally on a router. For example you can configure router1(say
> 10.10.10.1) to have AD of 111 for 200.200.200.0/24 network received from
> router2(10.10.10.2).
> configuration:
> ==========================
> ROUTER1:
> access-list 11 permit 200.200.200.0
> router eigrp xxx
> distance 111 10.10.10.2 0.0.0.0 11
> distance xxx neighbor ip wildcardmask access-list (In ospf this neibor ip
> must be router-id of the router)
> ==========================
> The above commands makes AD of 200.200.200.0 network leaned from 10.10.10.2
> neighbor to appear in R1 routing table as 111, so if the same network is
> leared by ospf too(AD= 110), The router R1 perfers ospf routes over eigrp
> routes.
>
> thanks
>
> Mani
>
> "22Cent@gmail.com" <22cent@gmail.com> wrote:
> Hello Group,
> Can anyone confirm if the eigrp distance command can be applied to a
> specific neighbor using an access-list to change one advertised
> network? Any help would be great.
>
> TIA
> Ray
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
> B.ENG,MCSE,CCNP,CCSP,CCIE#14645
> (416)431 9929
> MANI_CCIE@YAHOO.COM
>
> ________________________________
> Yahoo! Mail Mobile
> Take Yahoo! Mail with you! Check email on your mobile phone.
This archive was generated by hypermail 2.1.4 : Fri Jun 03 2005 - 10:11:58 GMT-3