RE: BSR on loopback

From: Gary Cheung (garymsue@netvigator.com)
Date: Fri May 13 2005 - 14:06:11 GMT-3

• Next message: T. N. Noble: "Setting Busy Message"
• Previous message: john matijevic: "vpn setting"
• Maybe in reply to: ccie zeng: "BSR on loopback"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Zeng

You should enable IP PIM SPARSE-MODE on Loopback.

Regards
Gary Cheung
CCIE#14642, BEng, CEng, MIEE, PMP, PRINCE2,
CISSP, MCSE, SCSA, SCNA

-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of ccie zeng
Sent: Friday, May 13, 2005 12:27 PM
To: Cisco certification
Subject: BSR on loopback

Hi:
should I must enable ip pim on loopback address if I use loopback as
the rp-candidate and bsr-candidate

Thanks
Zeng

• Next message: T. N. Noble: "Setting Busy Message"
• Previous message: john matijevic: "vpn setting"
• Maybe in reply to: ccie zeng: "BSR on loopback"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Jun 03 2005 - 10:11:58 GMT-3