From: ccie2be (ccie2be@nyc.rr.com)
Date: Fri May 06 2005 - 16:16:20 GMT-3
Gary,
1. The dialer load-threshold command can be configured on only 1 side or
both sides. However, if it's configured on both sides, you don't want the
command to bring up the 2nd circuit at the same time since then it's
possible for both sides to try to bring up the circuit and both sides will
find the 2nd circuit busy.
2. I don't think there's any difference but the best way to be sure is to
use the show policy-map intX command to see the results.
HTH, Tim
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Gary
Cheung
Sent: Friday, May 06, 2005 1:42 PM
To: ccielab@groupstudy.com
Subject: 2 quick questions
1) does the command " dialer load-threshold" require to enter in both ISDN
routers or single router only?
2) Any difference in between this two command "police" and "police cir"? Any
criteria in choosing between them?
Gary
This archive was generated by hypermail 2.1.4 : Fri Jun 03 2005 - 10:11:56 GMT-3