From: Pierre-Alex Guanel (paguanel@hotmail.com)
Date: Wed May 04 2005 - 18:19:13 GMT-3
To my knowledge, dialer interface over FR is not supported.
However it works on ATM
Pierre-Alex
----- Original Message -----
From: "Jim" <quangnn@hptvietnam.com.vn>
To: "doujie garcia" <doujie@hotmail.com>; "Cisco certification"
<ccielab@groupstudy.com>
Sent: Wednesday, May 04, 2005 11:26 AM
Subject: Re: PPPover Frame Relay
> I think it's normal behaviour since visual-access interface is real one
> which shows whether the link is up or down. also with virtual-interface in
> PPPoFR or PPPoA, we cannot ping the virtual-interface itself. So if the
task
> requires that local interface should be "pingable", it better to use
dialer
> interface instead of virtual-interface. One question, can I use dialer
> interface over FR? I've never try this before!
>
> Jim.
>
> ----- Original Message -----
> From: "doujie garcia" <doujie@hotmail.com>
> To: <ccielab@groupstudy.com>
> Sent: Wednesday, May 04, 2005 2:14 PM
> Subject: PPPover Frame Relay
>
>
> > Hi,
> >
> > I would just like to inquire if iis it normal that the virtual-template
> > interface is always down and the virtual-access interface is the one
> > interface that is up when configuring PPP over FR? and is it also the
> > normal behavior that you can not ping your own ip address defined in
your
> > virtual-interface in PPP over FR configuration?
> >
> > Best,
> > Doujie
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Jun 03 2005 - 10:11:56 GMT-3