From: ccie2be (ccie2be@nyc.rr.com)
Date: Fri Apr 22 2005 - 17:54:08 GMT-3
Hey Scott,
Thanks and I'll let Cisco know I appreciate the fact they're using as little
paper as possible to save our forests :-)
Also, when you say "non-broadcast" networks, you're referring to underlying
physical network as opposed to the ospf network type, right?
So, for example, if I'm using an ospf network type of point-to-multipoint
over a f/r network, do I still need the neighbor command or does this work
the same way as with ospf using ipv4?
Thanks again, Tim
-----Original Message-----
From: Scott Morris [mailto:swm@emanon.com]
Sent: Friday, April 22, 2005 4:19 PM
To: 'ccie2be'; 'Group Study'
Subject: RE: ospf v3
This works pretty much the same as OSPFv2. With non-broadcast you need it.
Both sides is fine, but only one side is necessary.
They were just saving space by writing that document so thin on content. :)
Scott
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
ccie2be
Sent: Friday, April 22, 2005 3:54 PM
To: Group Study
Subject: ospf v3
Hi guys,
The Doc-CD says that when running ospf v3 on nbma networks, you must
configure the neighbor command but it doesn't elaborate.
Does this mean the neighbor command must be configured on both sides of the
vc and is this command required regardless of what type of ospf network is
specified?
TIA, Tim
This archive was generated by hypermail 2.1.4 : Tue May 03 2005 - 07:55:07 GMT-3