From: mani poopal (mani_ccie@yahoo.com)
Date: Fri Apr 22 2005 - 09:35:43 GMT-3
Hi Scott and GS member;
I have a small(but important) doubt in MQC. Even after studying MQC a lot,
(1.)What is the default bandwidth for MQC is it 75% of interface bandwidth.
(2.)Say the interface bandwidth is 100MB,is it only 75 MB available for MQC, In that case is there is any default bandwidth allocated for class default.
(3.)Is there is any default bandwidht for class class-default and is it 75MB(assuming no classes are defined), If any classes are defined, what is the bandwidith for class class-default
(4.)the command -if)#max-reserve-bandwidth 90, the purpose, is it increases the bandwidth available for MQC or bandwidth available for class class-default
thanks
Mani
Scott Morris <swm@emanon.com> wrote:
Don't forget that "?" is your friend.
Emanon-R1(config)#policy-map Set-This
Emanon-R1(config-pmap)#class Who-Knows
Emanon-R1(config-pmap-c)#?
QoS policy-map class configuration commands:
bandwidth Bandwidth
compression Activate Compression
drop Drop all packets
exit Exit from QoS class action configuration mode
no Negate or set default values of a command
police Police
priority Strict Scheduling Priority for this Class
queue-limit Queue Max Threshold for Tail Drop
random-detect Enable Random Early Detection as drop policy
service-policy Configure QoS Service Policy
set Set QoS values
shape Traffic Shaping
Emanon-R1(config-pmap-c)#set ?
atm-clp Set ATM CLP bit to 1
cos Set IEEE 802.1Q/ISL class of service/user priority
discard-class Discard behavior identifier
dscp Set DSCP in IP(v4) and IPv6 packets
fr-de Set FR DE bit to 1
ip Set IP specific values
mpls Set MPLS specific values
precedence Set precedence in IP(v4) and IPv6 packets
qos-group Set QoS Group
Emanon-R1(config-pmap-c)#
-----Total Telnet Time 8.54 seconds-----
Scott
;)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of John
Matus
Sent: Thursday, April 21, 2005 6:26 PM
To: ccielab@groupstudy.com
Subject: precedence int cbwfq
is there a way to mark precedence in cbwfq?
This archive was generated by hypermail 2.1.4 : Tue May 03 2005 - 07:55:06 GMT-3