Re: system MTU and OSPF [bcc][faked-from]

From: Ian Henderson (ianh@chime.net.au)
Date: Tue Apr 12 2005 - 09:01:26 GMT-3

• Next message: Scott Morris: "RE: Frame relay traffic shaping ?"
• Previous message: SIMON HART: "Re: system MTU and OSPF [bcc][faked-from]"
• Maybe in reply to: Matt Mullen: "Re: system MTU and OSPF [bcc][faked-from]"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

On Tue, 12 Apr 2005, SIMON HART wrote:

> That's correct! If the system mtu was running at 1504, you would need
> to run the system mtu 1500 global config command and then reboot the
> device for the change to take effect

For OSPF, you can set 'ip mtu 1500' on a per-interface basis without
reloading. Works fine on my 3750's running 12.2(0.744)SE (a beta load of
12.2(25)SE).

Rgds,

- I.

--
Ian Henderson CCNA, CCNP
Senior Network Engineer
iiNet Limited
Chime Communications Pty Ltd

• Next message: Scott Morris: "RE: Frame relay traffic shaping ?"
• Previous message: SIMON HART: "Re: system MTU and OSPF [bcc][faked-from]"
• Maybe in reply to: Matt Mullen: "Re: system MTU and OSPF [bcc][faked-from]"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Tue May 03 2005 - 07:54:56 GMT-3