From: MANU mohan (cciemanu@rediffmail.com)
Date: Wed Mar 23 2005 - 01:19:00 GMT-3
Hi Dillon,
I can't see any dialer-group command on R1.Here you got the
ping because R2 would have been configured with "dialer-group 3 " in it's bri0
interface and R2 has initiated the call.Only R2 has "ip" as it's interesting
traffic and only interesting traffic can reset an idle-timer.So in R1's
perspective no traffic is interesting.So you have to apply "dialer-group" on
R1.Thanks.
Manu.
On Tue, 22 Mar 2005 Dillon Yang wrote :
>Hi, manu:
>
>
Just "dialer-list 3 p ip p", no any limit. Trust me. :)
>
>TIA
>dillon
>
>
>----- Original Message -----
> From: "MANU mohan" <cciemanu@rediffmail.com>
>To: "Dillon Yang" <gzdillon@hotmail.com>; <ccielab@groupstudy.com>
>Sent:
Tuesday, March 22, 2005 11:40 PM
>Subject: Re: idle-timeout
>
>
>Hi,
>?Can you
send the dialer-lists ? Is ping intersting traffic on both sides (Both echo &
echo-reply).Thanks.
>
>Manu
>
>On Tue, 22 Mar 2005 Dillon Yang wrote :
> >Hi,
group:
> >
> > I want somebody to help me on the command. You see, I set
idle-timeout 20 and made a big PING.
> >So the 2-way traffice exist, I think
the link is not IDLE. but at the 01:00:21 the DDR disconnect the call. Why?
>
>
> >TIA
> >dillon
> >
> >
> >=== Test one ===
> >
> >r1#p 172.16.12.2 rep
1000 size 500
> >
> >Type escape sequence to abort.
> >Sending 1000, 500-byte
ICMP Echos to 172.16.12.2, timeout is 2 seconds:
> >...
> >*Mar 1 01:00:01:
%LINK-3-UPDOWN: Interface BRI0:1, changed state to up.! <-- actived by R2
> >
> >( At the same time, back to R2, made a PING to bring up the link )
> >
>
>*Mar 1 01:00:01: BR0:1 DDR: dialer protocol up!!!!!!!
> >*Mar 1 01:00:02:
%LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:1, changed state to
> >
up!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
> >*Mar 1 01:00:07: %ISDN-6-CONNECT:
Interface BRI0:1 is now connected to 5550222 !!!!!!!!!!
> >!!!!!!!!!!!!
>
>!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
> >*Mar
1 01:00:21: BR0:1 DDR: idle timeout
> >*Mar 1 01:00:21: BR0:1 DDR:
disconnecting call
> >*Mar 1 01:00:21: %ISDN-6-DISCONNECT: Interface BRI0:1
disconnected from 5550222 , call l
> >asted 20 seconds
> >*Mar 1 01:00:21:
%LINK-3-UPDOWN: Interface BRI0:1, changed state to down
> >*Mar 1 01:00:21:
BR0:1 DDR: disconnecting call.
> >
> >*Mar 1 01:00:22: %LINEPROTO-5-UPDOWN:
Line protocol on Interface BRI0:1, changed state to
> >
down.................................
> >Success rate is 78 percent (135/173),
round-trip min/avg/max = 132/137/216 ms
> >
> >Current configuration : 264
bytes
> >!
> >interface BRI0
> > ip address 172.16.12.1 255.255.255.0
> >
encapsulation ppp
> > dialer idle-timeout 20
> > dialer map ip 172.16.12.2
broadcast 5550222
> > dialer map ip 172.16.12.2 broadcast 5550444
> > isdn
switch-type basic-ni
> > isdn spid1 555011101
> > isdn spid2 555022201
>
>end
> >
> >
> >======= Test two ======
> >
> >( Make a telnet session from R2
to R1, then 2-way traffic exist. But it disconnect after 20 second )
>
>r2#172.16.12.1
> >Trying 172.16.12.1 ...
> >*Mar 1 01:19:42: BR0 DDR:
Dialing cause ip (s=172.16.12.2, d=172.16.12.1)
> >*Mar 1 01:19:42: BR0 DDR:
Attempting to dial 5550111
> >*Mar 1 01:19:42: %LINK-3-UPDOWN: Interface
BRI0:1, changed state to up
> >*Mar 1 01:19:42: BR0:1 DDR: dialer protocol up
> >*Mar 1 01:19:43: %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:1,
changed state to
> > upOpen
> >
> >r1#s dial
> >
> >*Mar 1 01:19:48:
%ISDN-6-CONNECT: Interface BRI0:1 is now connected to 5550111
> >BRI0 - dialer
type = ISDN
> >
> >Dial String Successes Failures Last DNIS Last
status
> >5550444 0 0 never -
>
>5550222 0 0 never -
> >0
incoming call(s) have been screened.
> >0 incoming call(s) rejected for
callback.
> >
> >BRI0:1 - dialer type = ISDN
> >Idle timer (20 secs), Fast
idle timer (20 secs)
> >Wait for carrier (30 secs), Re-enable (15 secs)
>
>Dialer state is data link layer up
> >Time until disconnect 12 secs
<------------------------- Here !
> >Connected to 5550222
> >
> >BRI0:2 -
dialer type = ISDN
> >Idle timer (20 secs), Fast idle timer (20 secs)
> >Wait
for carrier (30 secs), Re-enable (15 secs)
> >Dialer state is idle
> >r1#s
dial
> >
> >BRI0 - dialer type = ISDN
> >
> >Dial String Successes
Failures Last DNIS Last status
> >5550444 0 0
never -
> >5550222 0 0 never
-
> >0 incoming call(s) have been screened.
> >0 incoming call(s) rejected for
callback.
> >
> >BRI0:1 - dialer type = ISDN
> >Idle timer (20 secs), Fast
idle timer (20 secs)
> >Wait for carrier (30 secs), Re-enable (15 secs)
>
>Dialer state is data link layer up
> >Time until disconnect 7 secs
<------------------------- Here !
> >Connected to 5550222
> >
> >BRI0:2 -
dialer type = ISDN
> >Idle timer (20 secs), Fast idle timer (20 secs)
> >Wait
for carrier (30 secs), Re-enable (15 secs)
> >Dialer state is idle
> >r1#s
dial
> >
> >BRI0 - dialer type = ISDN
> >
> >Dial String Successes
Failures Last DNIS Last status
> >5550444 0 0
never -
> >5550222 0 0 never
-
> >0 incoming call(s) have been screened.
> >0 incoming call(s) rejected for
callback.
> >
> >BRI0:1 - dialer type = ISDN
> >Idle timer (20 secs), Fast
idle timer (20 secs)
> >Wait for carrier (30 secs), Re-enable (15 secs)
>
>Dialer state is data link layer up
> >Time until disconnect 2 secs
<------------------------- Here !
> >Connected to 5550222
> >
> >BRI0:2 -
dialer type = ISDN
> >Idle timer (20 secs), Fast idle timer (20 secs)
> >Wait
for carrier (30 secs), Re-enable (15 secs)
> >Dialer state is idle
> >
> >r1#s
dial
> >
> >BRI0 - dialer type = ISDN
> >
> >Dial String Successes
Failures Last DNIS Last status
> >5550444 0 0
never -
> >5550222 0 0 never
-
> >0 incoming call(s) have been screened.
> >0 incoming call(s) rejected for
callback.
> >
> >BRI0:1 - dialer type = ISDN
> >Idle timer (20 secs), Fast
idle timer (20 secs)
> >Wait for carrier (30 secs), Re-enable (15 secs)
>
>Dialer state is data link layer up
> >Time until disconnect 0 secs
<------------------------- Here !
> >Connected to 5550222
> >
> >BRI0:2 -
dialer type = ISDN
> >Idle timer (20 secs), Fast idle timer (20 secs)
> >Wait
for carrier (30 secs), Re-enable (15 secs)
> >Dialer state is idle
> >r1#
>
>*Mar 1 01:20:02: %ISDN-6-DISCONNECT: Interface BRI0:1 disconnected from
5550111 , call l
> >asted 19 seconds
> >*Mar 1 01:20:02: %LINK-3-UPDOWN:
Interface BRI0:1, changed state to down
> >*Mar 1 01:20:02: BR0:1 DDR:
disconnecting call
> >*Mar 1 01:20:03: %LINEPROTO-5-UPDOWN: Line protocol on
Interface BRI0:1, changed state to
> > down
> >
> > ====
> >
>
>_______________________________________________________________________
>
>Subscription information may be found at:
>
>http://www.groupstudy.com/list/CCIELab.html
>
>_______________________________________________________________________
>Subscription information may be found at:
>http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sun Apr 03 2005 - 17:56:50 GMT-3