From: Dillon Yang (gzdillon@hotmail.com)
Date: Tue Mar 22 2005 - 13:02:23 GMT-3
Hi, manu:
Just "dialer-list 3 p ip p", no any limit. Trust me. :)
TIA
dillon
----- Original Message -----
From: "MANU mohan" <cciemanu@rediffmail.com>
To: "Dillon Yang" <gzdillon@hotmail.com>; <ccielab@groupstudy.com>
Sent: Tuesday, March 22, 2005 11:40 PM
Subject: Re: idle-timeout
Hi,
?Can you send the dialer-lists ? Is ping intersting traffic on both sides (Both echo & echo-reply).Thanks.
Manu
On Tue, 22 Mar 2005 Dillon Yang wrote :
>Hi, group:
>
> I want somebody to help me on the command. You see, I set idle-timeout 20 and made a big PING.
>So the 2-way traffice exist, I think the link is not IDLE. but at the 01:00:21 the DDR disconnect the call. Why?
>
>TIA
>dillon
>
>
>=== Test one ===
>
>r1#p 172.16.12.2 rep 1000 size 500
>
>Type escape sequence to abort.
>Sending 1000, 500-byte ICMP Echos to 172.16.12.2, timeout is 2 seconds:
>...
>*Mar 1 01:00:01: %LINK-3-UPDOWN: Interface BRI0:1, changed state to up.! <-- actived by R2
>
>( At the same time, back to R2, made a PING to bring up the link )
>
>*Mar 1 01:00:01: BR0:1 DDR: dialer protocol up!!!!!!!
>*Mar 1 01:00:02: %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:1, changed state to
> up!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
>*Mar 1 01:00:07: %ISDN-6-CONNECT: Interface BRI0:1 is now connected to 5550222 !!!!!!!!!!
>!!!!!!!!!!!!
>!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
>*Mar 1 01:00:21: BR0:1 DDR: idle timeout
>*Mar 1 01:00:21: BR0:1 DDR: disconnecting call
>*Mar 1 01:00:21: %ISDN-6-DISCONNECT: Interface BRI0:1 disconnected from 5550222 , call l
>asted 20 seconds
>*Mar 1 01:00:21: %LINK-3-UPDOWN: Interface BRI0:1, changed state to down
>*Mar 1 01:00:21: BR0:1 DDR: disconnecting call.
>
>*Mar 1 01:00:22: %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:1, changed state to
> down.................................
>Success rate is 78 percent (135/173), round-trip min/avg/max = 132/137/216 ms
>
>Current configuration : 264 bytes
>!
>interface BRI0
> ip address 172.16.12.1 255.255.255.0
> encapsulation ppp
> dialer idle-timeout 20
> dialer map ip 172.16.12.2 broadcast 5550222
> dialer map ip 172.16.12.2 broadcast 5550444
> isdn switch-type basic-ni
> isdn spid1 555011101
> isdn spid2 555022201
>end
>
>
>======= Test two ======
>
>( Make a telnet session from R2 to R1, then 2-way traffic exist. But it disconnect after 20 second )
>r2#172.16.12.1
>Trying 172.16.12.1 ...
>*Mar 1 01:19:42: BR0 DDR: Dialing cause ip (s=172.16.12.2, d=172.16.12.1)
>*Mar 1 01:19:42: BR0 DDR: Attempting to dial 5550111
>*Mar 1 01:19:42: %LINK-3-UPDOWN: Interface BRI0:1, changed state to up
>*Mar 1 01:19:42: BR0:1 DDR: dialer protocol up
>*Mar 1 01:19:43: %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:1, changed state to
> upOpen
>
>r1#s dial
>
>*Mar 1 01:19:48: %ISDN-6-CONNECT: Interface BRI0:1 is now connected to 5550111
>BRI0 - dialer type = ISDN
>
>Dial String Successes Failures Last DNIS Last status
>5550444 0 0 never -
>5550222 0 0 never -
>0 incoming call(s) have been screened.
>0 incoming call(s) rejected for callback.
>
>BRI0:1 - dialer type = ISDN
>Idle timer (20 secs), Fast idle timer (20 secs)
>Wait for carrier (30 secs), Re-enable (15 secs)
>Dialer state is data link layer up
>Time until disconnect 12 secs <------------------------- Here !
>Connected to 5550222
>
>BRI0:2 - dialer type = ISDN
>Idle timer (20 secs), Fast idle timer (20 secs)
>Wait for carrier (30 secs), Re-enable (15 secs)
>Dialer state is idle
>r1#s dial
>
>BRI0 - dialer type = ISDN
>
>Dial String Successes Failures Last DNIS Last status
>5550444 0 0 never -
>5550222 0 0 never -
>0 incoming call(s) have been screened.
>0 incoming call(s) rejected for callback.
>
>BRI0:1 - dialer type = ISDN
>Idle timer (20 secs), Fast idle timer (20 secs)
>Wait for carrier (30 secs), Re-enable (15 secs)
>Dialer state is data link layer up
>Time until disconnect 7 secs <------------------------- Here !
>Connected to 5550222
>
>BRI0:2 - dialer type = ISDN
>Idle timer (20 secs), Fast idle timer (20 secs)
>Wait for carrier (30 secs), Re-enable (15 secs)
>Dialer state is idle
>r1#s dial
>
>BRI0 - dialer type = ISDN
>
>Dial String Successes Failures Last DNIS Last status
>5550444 0 0 never -
>5550222 0 0 never -
>0 incoming call(s) have been screened.
>0 incoming call(s) rejected for callback.
>
>BRI0:1 - dialer type = ISDN
>Idle timer (20 secs), Fast idle timer (20 secs)
>Wait for carrier (30 secs), Re-enable (15 secs)
>Dialer state is data link layer up
>Time until disconnect 2 secs <------------------------- Here !
>Connected to 5550222
>
>BRI0:2 - dialer type = ISDN
>Idle timer (20 secs), Fast idle timer (20 secs)
>Wait for carrier (30 secs), Re-enable (15 secs)
>Dialer state is idle
>
>r1#s dial
>
>BRI0 - dialer type = ISDN
>
>Dial String Successes Failures Last DNIS Last status
>5550444 0 0 never -
>5550222 0 0 never -
>0 incoming call(s) have been screened.
>0 incoming call(s) rejected for callback.
>
>BRI0:1 - dialer type = ISDN
>Idle timer (20 secs), Fast idle timer (20 secs)
>Wait for carrier (30 secs), Re-enable (15 secs)
>Dialer state is data link layer up
>Time until disconnect 0 secs <------------------------- Here !
>Connected to 5550222
>
>BRI0:2 - dialer type = ISDN
>Idle timer (20 secs), Fast idle timer (20 secs)
>Wait for carrier (30 secs), Re-enable (15 secs)
>Dialer state is idle
>r1#
>*Mar 1 01:20:02: %ISDN-6-DISCONNECT: Interface BRI0:1 disconnected from 5550111 , call l
>asted 19 seconds
>*Mar 1 01:20:02: %LINK-3-UPDOWN: Interface BRI0:1, changed state to down
>*Mar 1 01:20:02: BR0:1 DDR: disconnecting call
>*Mar 1 01:20:03: %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:1, changed state to
> down
>
> ====
>
>_______________________________________________________________________
>Subscription information may be found at:
>http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sun Apr 03 2005 - 17:56:49 GMT-3