From: "Hoonpongsimanont
Date: Tue Mar 22 2005 - 07:46:40 GMT-3
Khalid,
Be careful. If you were asked to do that in the real exam, you should use
"length" line configuration mode command. Using "term length 0" will only
effect current connection and will lose its spell once disconnect.
Cheers,
David
-----Original Message-----
From: Nazgulero [mailto:pauwen@hotmail.com]
Sent: Tuesday, March 22, 2005 4:30 AM
To: khalid mehmood; Cisco certification
Subject: Re: disable "more" in output
Hello Khalid,
try:
terminal length 0
This will cause any output to autoscroll withoit pausing.
Regards,
Georg
----- Original Message -----
From: "khalid mehmood" <kmehmood@shaw.ca>
To: "Cisco certification" <ccielab@groupstudy.com>
Sent: Sunday, March 20, 2005 8:32 PM
Subject: disable "more" in output
> Hi,
>
> Is it possible to disable 'more' in the show command outputs.
>
> Like if i say show ip route and if there are more than 24 lines in the
output
> it should just spit it out
>
> KM
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sun Apr 03 2005 - 17:56:49 GMT-3