From: Danshtr (danshtr@gmail.com)
Date: Fri Mar 18 2005 - 05:58:04 GMT-3
Spanning tree is to prevent loops.
As long as your port will not be used to form a loop, then it should work.
On Fri, 18 Mar 2005 17:06:59 +0900 (JST), Tom Young
<gitsyoung@yahoo.co.jp> wrote:
> hi, group
> look at the sample below, if I set the vlan80 to the
> voice vlan, the voice vlan port will becomes port fast
> automatically, if I also set the no spanning-tree vlan
> 1,80 command, some proble will occur ?
>
> Thanks
>
> spanning-tree mode pvst
> no spanning-tree optimize bpdu transmission
> spanning-tree extend system-id
> no spanning-tree vlan 1,80
> !
> !
> interface FastEthernet0/1
> switchport mode access
> switchport voice vlan 80
> speed 10
> duplex half
> mls qos trust cos
> spanning-tree portfast
>
> __________________________________
> Do You Yahoo!?
> Upgrade Your Life
> http://bb.yahoo.co.jp/
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
-- Best regards, Dan
This archive was generated by hypermail 2.1.4 : Sun Apr 03 2005 - 17:56:47 GMT-3