Bridging

From: syed.ali@ualberta.ca
Date: Tue Mar 15 2005 - 13:50:02 GMT-3

• Next message: Edwards, Andrew M: "RE: Bridging"
• Previous message: Ed Lui: "Re: ISDN Time until disconnect"
• Next in thread: Edwards, Andrew M: "RE: Bridging"
• Maybe reply: Edwards, Andrew M: "RE: Bridging"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

I have a question regarding configuring a GRE tunnel and Bridging. I have a
GRE tunnel configured from a Cisco 1200 series Wireless Access Point to a
Catalyst 6509 running Native IOS. I am using a Loopback address as the
source of the tunnel on the 6509. I am trying to bridge the loopback address
and a Vlan. I have configured Bridging (IRB)

I am not able to add a bridge-group to the loopback address or add a BVI
interface.

This is some of the relevant configuration on the 6509

interface Tunnel0

 ip address " "

 tunnel source Loopback1

 tunnel destination " "

interface Loopback1

 ip address " "

interface Vlan19

 no ip address

 bridge-group 1

bridge irb

bridge 1 protocol vlan-bridge

bridge 1 route ip

• Next message: Edwards, Andrew M: "RE: Bridging"
• Previous message: Ed Lui: "Re: ISDN Time until disconnect"
• Next in thread: Edwards, Andrew M: "RE: Bridging"
• Maybe reply: Edwards, Andrew M: "RE: Bridging"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sun Apr 03 2005 - 17:56:46 GMT-3