From: Jongsoo.Kim@Intelsat.com
Date: Sun Mar 13 2005 - 16:23:21 GMT-3
I don't think many of you know about this new command 12.2T.
At least, I found out this today. It may answer one of my QoS questions I
couldn't answer a few weeks.
Pay attention on units "bits" vs "bps"
If question said " police 1Mbps with normal burst = 64Kbits.
police 1000000 8000 conform-action transmit exceed-action drop
But if question ask " police 1 Mbps with burst rate of 64Kbps", how can you
configure?
Maybe it should say peak-rate instead of burst rate?
At least, I am thinking
police cir 1000000 pir 1064000 conform-action transmit exceed-action
transmit violate-action drop
Any feedback is welcomed.
Regards
Jongsoo
############################################################
Building on 40 Years of Leadership - As a global communications leader with 40 years of experience, Intelsat helps service providers,
broadcasters, corporations and governments deliver information and entertainment anywhere in the world, instantly, securely and reliably.
############################################################
This email message is for the sole use of the intended
recipient(s) and may contain confidential and privileged
information. Any unauthorized review, use, disclosure or
distribution is prohibited. If you are not the intended
recipient, please contact the sender by reply email and
destroy all copies of the original message. Any views
expressed in this message are those of the individual
sender, except where the sender specifically states them
to be the views of Intelsat, Ltd. and its subsidiaries.
############################################################
This archive was generated by hypermail 2.1.4 : Sun Apr 03 2005 - 17:56:45 GMT-3