From: marvin greenlee (marvin@ccbootcamp.com)
Date: Fri Mar 11 2005 - 21:39:07 GMT-3
Sdm prefer VLAN
Cisco - Understand and Configure the Switching Database Manager on Catalyst
3550 Series Switches -
http://www.cisco.com/en/US/products/hw/switches/ps646/products_tech_note0918
6a0080094bc6.shtml
Marvin Greenlee, CCIE#12237, CCSI# 30483
Network Learning Inc
marvin@ccbootcamp.com
www.ccbootcamp.com (Cisco Training)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Church, Chuck
Sent: Friday, March 11, 2005 4:33 PM
To: Andre Scalco; ccielab@groupstudy.com
Subject: RE: CAT3550 - Layer 2 Only [bcc][faked-from]
Importance: Low
Not applying any IP addresses to VLANs or ports should do it.
Chuck Church
Lead Design Engineer
CCIE #8776, MCNE, MCSE
Netco Government Services - Design & Implementation Team
1210 N. Parker Rd.
Greenville, SC 29609
Home office: 864-335-9473
Cell: 703-819-3495
cchurch@netcogov.com
PGP key: http://pgp.mit.edu:11371/pks/lookup?op=get&search=0x4371A48D
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Andre Scalco
Sent: Friday, March 11, 2005 7:24 PM
To: ccielab@groupstudy.com
Subject: CAT3550 - Layer 2 Only
Hello Guys,
How do I make sure a Cat3550 will act only as a layer2 device without
use the "no ip routing" command?
Thanks!
Best Regards,
Andre Scalco
"Think Outside the Bun"
This archive was generated by hypermail 2.1.4 : Sun Apr 03 2005 - 17:56:45 GMT-3