From: marvin greenlee (marvin@ccbootcamp.com)
Date: Tue Mar 08 2005 - 21:25:03 GMT-3
Why not just use GLBP, and have DHCP hand out the GLBP address as the
gateway?
Marvin Greenlee, CCIE#12237, CCSI# 30483
Network Learning Inc
marvin@ccbootcamp.com
www.ccbootcamp.com (Cisco Training)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
ccie2be
Sent: Tuesday, March 08, 2005 3:01 PM
To: Group Study
Subject: MHSRP & DHCP [bcc][faked-from]
Importance: Low
Hi Guys,
I think this is an interesting scenario.
rtr-x rtr-y
|-----------| <--vlan 10
Requirement: Configure the rtr's such that the hosts on vlan 10 split their
traffic approx 50/50 between the rtr's.
If one of the rtr's fails, the other router should handle all the traffic,
but when the failed router comes back into service,
the traffic should again be split 50/50.
Partial Solution:
Configure dhcp on both routers and config mhsrp.
Questions:
1) Assuming both routers are up, what determines which of dhcp server hands
out ip addresses when a PC powers up?
2) If one of the routers is down for a while, the other dhcp server on the
other server will be handing out ip addresses. If a lot of
PC's power up during that period or have to renew their dhcp lease, they'll
all end up using the up router as their gateway. Is there any way
to make such that after the failed router comes back up, the traffic load
will be well balanced?
TIA, Tim
This archive was generated by hypermail 2.1.4 : Sun Apr 03 2005 - 17:56:43 GMT-3