From: Bajo (bajoalex@gmail.com)
Date: Fri Mar 04 2005 - 12:59:23 GMT-3
Hi Dillon,
Can U do passive on the interface advertising it?
How about "Ip split-horizon" command ? Remember If the serials are
using FR, split is OFF.
On Fri, 4 Mar 2005 23:42:45 +0800, Dillon Yang <gzdillon@hotmail.com> wrote:
> Hi, dear all:
>
> I'm confused by this topology:
>
> |ospf----------(s0/1)R3(s0/2)-----------isis-
> | | ospf |
> | | |
> | |------eigrp------R1(s0/2)---------isis| |
> | | | |
> (1)(2) (s0/1)(s0/2)
> R2(3)-----eigrp-----------------------(s0/1)R4------150.100.2.3-------Ethernet
>
> Though I shutdown the e0 of R4, the address 150.100.2.0/24 is still seen in the 3 protocol.
> I can not prevent routing loop in the case by using "distance xxx address/mask <acl>".
> Any advice?
>
> dillon
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
-- Kind Regards,Bajo
This archive was generated by hypermail 2.1.4 : Sun Apr 03 2005 - 17:56:40 GMT-3