From: Gajewski Mariusz (Mariusz.Gajewski@telekomunikacja.pl)
Date: Sun Feb 27 2005 - 12:08:29 GMT-3
Try - show interf s0/0 precedence
hth
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
mikenoc@mindspring.com
Sent: Sunday, February 27, 2005 3:59 PM
To: ccielab@groupstudy.com
Subject: IE Lab 1 task 12.1 trying to verify if config is working
Hello,
On this task we are supposed to enable IP accounting to see if any packets
going across the frame link are being marked with an IP precedence value. To
verify this I tried to I tried setting IP precedence with CAR for anything
over 8000 bytes. I then tried pinging across the circuit changing the MTU to
1500 and when doing a show ip accounting on both interfaces I am not seeing
anything. Can someone please take a look at my config and tell me what I am
missing ?
Thanks,
Mike F.
Rack1R2#sh run int ser 0/0
Building configuration...
Current configuration : 367 bytes
!
interface Serial0/0
ip address 183.1.123.2 255.255.255.0
ip accounting precedence input
ip accounting precedence output
ip pim sparse-dense-mode
encapsulation frame-relay IETF
no ip split-horizon eigrp 100
frame-relay map ip 183.1.123.1 201 broadcast
frame-relay map ip 183.1.123.3 203 broadcast
no frame-relay inverse-arp
frame-relay lmi-type cisco
end
Rack1R2#
Rack1R3#sh run int ser 0/0
Building configuration...
Current configuration : 429 bytes
!
interface Serial0/0
ip address 183.1.123.3 255.255.255.0
ip accounting precedence input
ip accounting precedence output
ip pim sparse-dense-mode
rate-limit output 8000 1500 2000 conform-action set-prec-transmit 5
exceed-action set-prec-transmit 3 encapsulation frame-relay IETF
frame-relay map ip 183.1.123.1 302 frame-relay map ip 183.1.123.2 302
broadcast no frame-relay inverse-arp frame-relay lmi-type cisco end
Rack1R3#
Rack1R3#ping ip
Target IP address: 183.1.123.2
Repeat count [5]: 10000
Datagram size [100]: 1500
Timeout in seconds [2]:
Extended commands [n]:
Sweep range of sizes [n]:
Type escape sequence to abort.
Sending 10000, 1500-byte ICMP Echos to 183.1.123.2, timeout is 2 seconds:
!!!!!! Terminal#2
Rack1R2#sh ip accounting
Rack1R2#
Rack1R3#sh ip accounting
Rack1R3#
This archive was generated by hypermail 2.1.4 : Thu Mar 03 2005 - 08:51:26 GMT-3