From: MERRILL SR., JAMES D \(AIT\) (jm8752@sbc.com)
Date: Wed Feb 16 2005 - 17:45:29 GMT-3
Not the same problem but I have a customer that has 3 7204VXR routers
with NPE-G1s that when a reload is issued the router hangs and you have
to either power cycle the router or issue the reset command in Rommon
mode. The main problem is that if you turn around and issue the reload
right away it reloads fine. It takes between 3 and 7 days between
reloads to reproduce the problem. This has been going on since June 04.
Cisco just moved the problem to P1.
I didn't see the same problem when I has an IO processor module when I
had the IO processor module I had the failure like you showed.
James D. Merrill
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
vol
Sent: Wednesday, February 16, 2005 7:47 AM
To: ccielab@groupstudy.com
Subject: boot system trouble with my 7206NPE-G1
Hi all!
Is anyone see the same after reloading cisco:
Proceed with reload? [confirm]
000025: *Feb 16 16:39:38.460 MSK: %SYS-5-RELOAD: Reload requested by
console. Reload Reason: Reload command.
System Bootstrap, Version 12.3(4r)T1, RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 2003 by cisco Systems, Inc.
C7200 platform with 262144 Kbytes of main memory
Readonly ROMMON initialized
Self decompressing the image :
########################################################## [OK]
*** TLB (Load/Fetch) Exception ***
Access address = 0xffffdc97
PC = 0x87ff7820, SP = 0x87fffe10, RA = 0x80009858
Cause Reg = 0x00000008, Status Reg = 0x3040d003
monitor: command "boot" aborted due to exception
System Bootstrap, Version 12.3(4r)T1, RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 2003 by cisco Systems, Inc.
C7200 platform with 262144 Kbytes of main memory
Readonly ROMMON initialized
Self decompressing the image :
########################################################################
########################################################################
#### [OK]
*** Emulating mis-aligned store at 0x000077ff
PC = 0x87ff7800 ... failed, opcode = 0x0
monitor: command "boot" aborted due to exception
System Bootstrap, Version 12.3(4r)T1, RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 2003 by cisco Systems, Inc.
C7200 platform with 262144 Kbytes of main memory
Readonly ROMMON initialized
string is disk2:c7200-js-mz.123-2.T9.bin
-- With best wishes, Yevgeniy.
This archive was generated by hypermail 2.1.4 : Thu Mar 03 2005 - 08:51:21 GMT-3