From: gladston@br.ibm.com
Date: Tue Feb 08 2005 - 19:55:36 GMT-3
And I though ODR was very simple...
R3 is configured to ODR. It is the hub router. R3 is connected to R2.
R3 see R2 as CDP neighbor, but it does not learn routes from R2.
To see if it was something wrong with Frame Relay, this is other example that also does not work:
R6 is connected to R7 via ppp. R6 sees R7 as CDP neighbor, but does not learn any connected route from R7.
Any Recommendation?
The only command used was:
router odr
And certify that cdp is running.
r6#sh cdp ne
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater
Device ID Local Intrfce Holdtme Capability Platform Port ID
sw1 Eth 1 156 T S WS-C2924C-Fas 0/9
sw1 Eth 0 156 T S WS-C2924C-Fas 0/8
r1 Ser 0 120 R 3620 Ser 0/1
r7 Ser 1 139 R 2500 Ser 0
r6#
r6#sh ip route odr
r6#sh run | b router odr
router odr
!
This archive was generated by hypermail 2.1.4 : Thu Mar 03 2005 - 08:51:18 GMT-3