From: Richard Dumoulin (Richard.Dumoulin@vanco.fr)
Date: Mon Feb 07 2005 - 10:48:31 GMT-3
Did you configure the receiving side with a dialer-idle timeout of 0? If not
then give it a try.
-- Richard
-----Original Message-----
From: Mark Muhi [mailto:markmuhi@hotmail.com]
Sent: Monday, February 07, 2005 2:36 PM
To: ccielab@groupstudy.com
Subject: Behavior of Dialer-watch with OSPF
Hi all,
I have two questions regarding a weird behavior that I have when configuring
dialer-watch with OSPF.
1 When the idle-timeout expires and the watched routes are still
missing, the BRI interface goes DOWN and then UP again immediately. I would
expect that if the watched routes are still missing then the BRI
interface should stay up and never go down??
2 Even when I change the idle-time-out to say 150 seconds, the call will
last only for 60 seconds. I would expect it here to start looking for the
routes after 150 seconds and not 60 seconds.
Are the above behaviors normal?
Regards,
Mark
This archive was generated by hypermail 2.1.4 : Thu Mar 03 2005 - 08:51:17 GMT-3