From: mmj (groupstudy@users.hotpop.com)
Date: Fri Dec 31 2004 - 15:51:17 GMT-3
Helena,
Some about statics:
I am looking at 501, cannot add separate gateways for one route.
route inside 1.1.1.0 255.255.255.0 10.99.99.2 20
route inside 1.1.1.0 255.255.255.0 10.99.99.3 20
cannot add route entry. possible conflict with existing routes
Usage: [no] route <if_name> <foreign_ip> <mask> <gateway> [<metric>]
OSPF: PIX Does run a routing protocol, I do not recommend that.
What you can do is divide the non rfc 1918 addresses (split public
destinations) between routes, i never did that.
If we go outside the pix:
what hardware router is your telco delivering,
will that be times 2, same as existing router.
what kind of load-balancing do you need, want,
are there vpn's involved,
do you host websites or whatever?
Martijn
-----Oorspronkelijk bericht-----
Van: nobody@groupstudy.com [mailto:nobody@groupstudy.com] Namens Helena Qiu
Verzonden: woensdag 22 december 2004 7:49
Aan: ccielab@groupstudy.com
Onderwerp: Load balancing in PIX 525?
Currently, we have one 6M internet access. We are using 1 PIX 525 as a
firewall to connect to ISP's network as following:
user --- access switch -- 3550 lay3 switch ---- Pix 525 ------------ISP
We are going to order another 6M link from the same ISP. Is it possible for
us to configure PIX to achieve load balancing?
Waiting for your suggestion. Thank you very much.
---------------------------------
Do you Yahoo!?
Take Yahoo! Mail with you! Get it on your mobile phone.
This archive was generated by hypermail 2.1.4 : Mon Jan 03 2005 - 10:31:33 GMT-3