From: Brian Dennis (bdennis@internetworkexpert.com)
Date: Thu Dec 30 2004 - 14:27:30 GMT-3
Did you try looking at the "show isdn status" command?
Router(config)#int br0/0
Router(config-if)#isdn spid1 5272044
Router(config-if)#no shut
Router(config-if)#
%LINK-3-UPDOWN: Interface BRI0/0:1, changed state to down
%LINK-3-UPDOWN: Interface BRI0/0:2, changed state to down
%LINK-3-UPDOWN: Interface BRI0/0, changed state to up
%ISDN-6-LAYER2UP: Layer 2 for Interface BR0/0, TEI 64 changed to up
%ISDN-4-INVALID_SPID: Interface BR0/0, Spid1 was rejected
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
%LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0/0:1, changed state
to down
%LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0/0:2, changed state
to down
Router(config-if)#do show isdn status
Global ISDN Switchtype = basic-ni
ISDN BRI0/0 interface
dsl 0, interface ISDN Switchtype = basic-ni
Layer 1 Status:
ACTIVE
Layer 2 Status:
TEI = 64, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
TEI 64, ces = 1, state = 6(not initialized)
spid1 configured, no LDN, spid1 sent, spid1 NOT valid
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Layer 3 Status:
0 Active Layer 3 Call(s)
Active dsl 0 CCBs = 0
The Free Channel Mask: 0x80000003
Total Allocated ISDN CCBs = 0
Router(config-if)#
Brian Dennis, CCIE #2210 R&S, ISP-Dial, Security
bdennis@internetworkexpert.com
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-224-8987
Direct: 775-745-6404 (Outside the US and Canada)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
johnsheahan@charter.net
Sent: Thursday, December 30, 2004 8:55 AM
To: ccielab@groupstudy.com
Subject: ISDN SPID Troubleshooting
I was trying to troubleshoot my ISDN connection yesterday when I had the
wrong
spids and I realized I don't know what to look for if I accidentally put
in
the wrong spid numbers.
I was performing debug isdn status and debug isdn q921 and q931 but did
not
see any spid errors.
Is there a different debug command I should use to troubleshoot this or
what
specific error message should I see in my debug if the spids are wrong?
Thanks
This archive was generated by hypermail 2.1.4 : Mon Jan 03 2005 - 10:31:32 GMT-3