Service-policy on ATM interface

From: David Duncon (david_ccie@hotmail.com)
Date: Mon Dec 06 2004 - 05:19:11 GMT-3

• Next message: TN Cyclist: "RE: HSRP, NAT, & the "no ip redirect" command"
• Previous message: Donny mateo Tandase: "Re: Face-Off - Dolye vs Deal on NAT"
• Next in thread: jatinder.p.singh@bt.com: "RE: Service-policy on ATM interface"
• Maybe reply: jatinder.p.singh@bt.com: "RE: Service-policy on ATM interface"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi Group,

I am trying to apply a CBWFQ on an ATM interface to control the Ingress feed
and when I tried to apply the service policy command , I am getting the
following errors.

In the end I could apply service policy neither inbound nor outbound.

I appreciate any feed back on this issue.

Rack01R6(config)#int atm0/0
Rack01R6(config-if)#service-policy inp
Rack01R6(config-if)#service-policy input limit
Rack01R6(config-if)#
*Mar 1 06:16:05.458: CBWFQ : Can be enabled as an output feature only
Rack01R6(config-if)#service-policy output limit
CBWFQ : Not supported on this interface
Rack01R6(config-if)#

Cheers

- David.

• Next message: TN Cyclist: "RE: HSRP, NAT, & the "no ip redirect" command"
• Previous message: Donny mateo Tandase: "Re: Face-Off - Dolye vs Deal on NAT"
• Next in thread: jatinder.p.singh@bt.com: "RE: Service-policy on ATM interface"
• Maybe reply: jatinder.p.singh@bt.com: "RE: Service-policy on ATM interface"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Mon Jan 03 2005 - 10:31:24 GMT-3