From: Sam Meftahi (cisco_lad2004@yahoo.co.uk)
Date: Fri Nov 26 2004 - 16:02:48 GMT-3
When configuring an ATM switch, I noticed that when a PVC is configured under an interface it might not necessarily appear under that specific interface but instead under the remote interface on wich the PVC is switched
So, if I configure
int atm0/0
PVC 100 100 interface ATM 1/1 200 200
when I do show run, this config appears under ATM1/1 as
PVC 200 200 interface ATM 0/0 100 100
Is there a rule that controls this behaviour, I suspect it is soemthing to do with VPI values ??
Any comments or links appreciated.
TIA
Marc
---------------------------------
Moving house? Beach bar in Thailand? New Wardrobe? Win #10k with Yahoo! Mail to make your dream a reality.
This archive was generated by hypermail 2.1.4 : Thu Dec 02 2004 - 06:57:50 GMT-3