From: adeolu@sympatico.ca
Date: Mon Nov 15 2004 - 05:38:19 GMT-3
Hi Dean,
You're correct but I just wanted to point out something....
Only the first command actually sets the IS type. The second command is used between L1-L2 routers to specify a specific type of adjacency on a particular interface. This command is useful where both routers are L1-L2 (the default) and belong to the same area on a particular link. This does not prevent the router from forming L2 adjacencies on other interfaces.
Hopefully, the lab will not leave any room for doubt but I guess you can always ask the proctor.
Just my opinion....
Ade
>
> From: "Dean Penebacker" <dean@penebacker.com>
> Date: 2004/11/15 Mon AM 12:14:16 EST
> To: <ccielab@groupstudy.com>
> Subject: isis router type
>
> Just want to make sure I understand this properly. In ISIS if you want to set
> the type level I've seen two different ways.
>
> 1)
>
> router isis
> is-type level-X
>
> 2)
>
> interface e0/0
> isis circuit-type level-X
>
>
> Am I correct in assuming that "is-type" command is a global for all interfaces
> and the "isis circuit-type" command is specific to that interface? Just want
> to make sure.
>
> Thanks for all your help!!
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Thu Dec 02 2004 - 06:57:45 GMT-3