From: Swaroop Potdar (swarooppotdar@hotmail.com)
Date: Sat Nov 13 2004 - 10:19:17 GMT-3
Hi All,
If I have say around 10 switches.
And all are trunked to each other and all the vlans are allowed on the
trunks.
Lets assume there are vlans 2,3,4,5,6
So if I want to monitor the port 10 on switch 1 of vlan 2 as the source
and my analyzer is on switch 7 on vlan 5 on port 12
In this case what would the configuration be.
And where the configuration would be applied.
-------------
Or is it so that we give the same session numbers on both these switches but
configure the source parameters on the switch 1 and destination parameters
on the switch 7 and the sessions negotiate automatically to send and receive
data at as per teh configuration....???
This is purely academic...as its quite a odd question.
Your inputs would be helpful as i havent found much doumentation on this
topic..
Thanks,
Swaroop.
Regards,
Swaroop.
------------------------------------------------------------------
Life Is Short & Sweet.
Live It To The Fullest.
------------------------------------------------------------------
This archive was generated by hypermail 2.1.4 : Thu Dec 02 2004 - 06:57:43 GMT-3