From: robbie (robbie@packetized.org)
Date: Mon Oct 25 2004 - 21:33:20 GMT-3
How did you use the FXS VIC in this scenario? The layout I'm looking at
doing basically consists of having a VWIC-2MFT-T1 running as a ISDN PRI
switch, with either PRI TE side equipment, or if I could somehow
configure the MFT-T1s as BRI, then use BRI equipment for the network side.
I don't know if I'm doing an adequate job of explaining what I want to
do; basically, I want to build an ISDN simulator (preferably BRI, but
PRI if necessary) out of Cisco equipment, if possible.
cheers,
robbie
DaveW wrote:
> Hey Robbie,
>
> I used two routers 3640/3745 with NM-HDV modules with VWIC-1MFT-T1 cards for
> a back-to-back PRI setup. I didn't have a PRI line to the local CO but
> needed something to test out my Call Manager/Gateway configuration. A router
> simulating the network side of the PRI configured with an FXS VIC (and
> phone)allowed me to call back and forth between my IP phones and the analog
> phone hanging off the "isdn protocol-emulate network" configured router. For
> testing purposes it worked great.
>
> -dave
> ----- Original Message -----
> From: "robbie" <robbie@packetized.org>
> To: <ccielab@groupstudy.com>
> Sent: Monday, October 25, 2004 7:48 PM
> Subject: isdn protocol-emulate network
>
>
>
>>Does anyone have a list (or know where I could same) of interfaces that
>>support this command, either PRI or BRI? I'm trying to see about
>>cobbling together some sort of ISDN simulator, but am having trouble
>>finding out exactly what modules support this configuration. Any help
>>greatly appreciated.
>>
>>cheers,
>>robbie
>>
>>_______________________________________________________________________
>>Subscription information may be found at:
>>http://www.groupstudy.com/list/CCIELab.html
>
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sat Nov 06 2004 - 17:11:52 GMT-3