From: Mike Flanagan (mikenoc@mindspring.com)
Date: Sun Oct 10 2004 - 22:35:33 GMT-3
Hello,
I am shutting down the interface, then enabling frame relay disabling
Frame relay inver arp and then re enabling the interface. After I am doing
All that I am still seeing quaud 0's in a show frame relay map command. Can
Anyone explain why this is happening and what I can do to prevent this.
Thanks,
Mike F.
Rack1R4#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Rack1R4(config)#int ser 0/0
Rack1R4(config-if)#shut
Rack1R4(config-if)#
*Mar 1 04:21:12.683: %LINK-5-CHANGED: Interface Serial0/0, changed state to
administratively down
Rack1R4(config-if)#encap
Rack1R4(config-if)#encapsulation frame
Rack1R4(config-if)#no frame
Rack1R4(config-if)#encap
Rack1R4(config-if)#encapsulation frame
Rack1R4(config-if)#encapsulation frame-relay
Rack1R4(config-if)#no frame
Rack1R4(config-if)#no frame-relay inver
Rack1R4(config-if)#no frame-relay inverse-arp
Rack1R4(config-if)#frame
Rack1R4(config-if)#frame-relay map ip 183.1.0.5 405 broad
Rack1R4(config-if)#frame-relay map ip 183.1.0.5 405 broadcast
Rack1R4(config-if)#frame-relay map ip 183.1.0.3 405
Rack1R4(config-if)#no shut
Rack1R4(config-if)#no shutdown
Rack1R4(config-if)#
*Mar 1 04:22:52.335: %LINK-3-UPDOWN: Interface Serial0/0, changed state to
up
Rack1R4(config-if)#end
Rack1R4#
*Mar 1 04:22:56.205: %SYS-5-CONFIG_I: Configured from console by console
Rack1R4#wr
Building configuration...
*Mar 1 04:23:03.337: %LINEPROTO-5-UPDOWN: Line protocol on Interface
Serial0/0, changed state to up[OK]
Rack1R4#sh frame
Rack1R4#sh frame-relay map
Serial0/0 (up): ip 0.0.0.0 dlci 413(0x19D,0x64D0)
broadcast,
CISCO, status defined, active
Serial0/0 (up): ip 0.0.0.0 dlci 403(0x193,0x6430)
broadcast,
CISCO, status defined, active
Serial0/0 (up): ip 0.0.0.0 dlci 402(0x192,0x6420)
broadcast,
CISCO, status defined, active
Serial0/0 (up): ip 0.0.0.0 dlci 401(0x191,0x6410)
broadcast,
CISCO, status defined, active
Serial0/0 (up): ip 183.1.0.3 dlci 405(0x195,0x6450), static,
CISCO, status defined, active
Serial0/0 (up): ip 183.1.0.5 dlci 405(0x195,0x6450), static,
broadcast,
CISCO, status defined, active
Rack1R4#
This archive was generated by hypermail 2.1.4 : Sat Nov 06 2004 - 17:11:46 GMT-3