From: nettable_walker (nettable_walker@hotmail.com)
Date: Fri Oct 01 2004 - 13:52:23 GMT-3
how about this :
El_Paso#config t
Enter configuration commands, one per line. End with CNTL/Z.
El_Paso(config)#int bri 0/0
El_Paso(config-if)#ip accounting outp
El_Paso(config-if)#
El_Paso#
El_Paso#
El_Paso#sh
00:42:21: %SYS-5-CONFIG_I: Configured from console by console
El_Paso#sh int bri 0/0 accou
BRI0/0
Protocol Pkts In Chars In Pkts Out Chars Out
No traffic sent or received on this interface.
El_Paso#
----- Original Message -----
From: "ccie2be" <ccie2be@nyc.rr.com>
To: "Group Study" <ccielab@groupstudy.com>
Sent: Friday, October 01, 2004 8:33 AM
Subject: Debug ip packet
> Hi guys,
>
> I hope this isn't a totally stupid question, but...
>
> Is there a way to configure debug ip packet so that I can see just the
> packets
> coming in or leaving a given interface?
>
> I know an acl an be attached to debug ip packet but I can't figure out a
> way
> to specify just a single interface.
>
> Thanks alot, Tim
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sat Nov 06 2004 - 17:11:41 GMT-3