From: ccie2be (ccie2be@nyc.rr.com)
Date: Fri Oct 01 2004 - 11:22:33 GMT-3
Hi Bob,
Thanks. This is great. I figured there had to be a way of doing this
although I had no idea what that would be.
I'm continually amazed by all the brain power I see here on GS.
Thanks again. Tim
----- Original Message -----
From: "Bob Sinclair" <bsinclair@netmasterclass.net>
To: "ccie2be" <ccie2be@nyc.rr.com>; "Group Study" <ccielab@groupstudy.com>
Sent: Friday, October 01, 2004 10:16 AM
Subject: Re: Debug ip packet
> Tim,
>
> You can set a debug "condition" that will show matches for only a
specified
> interface. The downside is that you MIGHT forget to explicitly remove it
> when your done! Then subsequent debugs will only show for the originally
> set condtion. Undebug all does NOT remove the interface condition. It
must
> be explicitly removed.
>
>
> R1#
> R1#
> R1#debug interface f0/0
> Condition 1 set
> R1#debug ip packet 101
> IP packet debugging is on for access list 101
> R1#sh debug
> Generic IP:
> IP packet debugging is on for access list 101
>
> R1#sh debug condition
>
> Condition 1: interface Fa0/0 (1 flags triggered)
> Flags: Fa0/0
>
> R1#no debug interface f0/0
> This condition is the last interface condition set.
> Removing all conditions may cause a flood of debugging
> messages to result, unless specific debugging flags
> are first removed.
>
> Proceed with removal? [yes/no]: yes
> Condition 1 has been removed
> R1#
> R1#u all
> All possible debugging has been turned off
> R1#
>
>
> Bob Sinclair
> CCIE #10427, CISSP, MCSE
> www.netmasterclass.net
>
> ----- Original Message -----
> From: "ccie2be" <ccie2be@nyc.rr.com>
> To: "Group Study" <ccielab@groupstudy.com>
> Sent: Friday, October 01, 2004 9:33 AM
> Subject: Debug ip packet
>
>
> > Hi guys,
> >
> > I hope this isn't a totally stupid question, but...
> >
> > Is there a way to configure debug ip packet so that I can see just the
> > packets
> > coming in or leaving a given interface?
> >
> > I know an acl an be attached to debug ip packet but I can't figure out a
> > way
> > to specify just a single interface.
> >
> > Thanks alot, Tim
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sat Nov 06 2004 - 17:11:41 GMT-3