From: Moffat, Ed (EMoffat@FSCI.com)
Date: Fri Oct 01 2004 - 11:08:44 GMT-3
debug condition interface <interface>
show debug condition will show you what conditions are set
no debug condition <#> or no debug condition <condition> will remove
the settings.
Be sure to do this when you are done or else the condition will remain
set until you reload your router. The undebug all command does not
remove the condition.
HTH
-Ed Moffat-
CCIE #13196
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
ccie2be
Sent: Friday, October 01, 2004 6:33 AM
To: Group Study
Subject: Debug ip packet
Hi guys,
I hope this isn't a totally stupid question, but...
Is there a way to configure debug ip packet so that I can see just the
packets coming in or leaving a given interface?
I know an acl an be attached to debug ip packet but I can't figure out a
way to specify just a single interface.
Thanks alot, Tim
This archive was generated by hypermail 2.1.4 : Sat Nov 06 2004 - 17:11:41 GMT-3