From: Tony Schaffran (groupstudy@cconlinelabs.com)
Date: Fri Sep 24 2004 - 04:23:39 GMT-3
Could you be more specific?
It sounds like your network command is wrong. If you could post your exact
config, we may be able to help point out the problem for you.
Tony Schaffran
Network Analyst
CCIE #11071
CCNP, CCNA, CCDA,
NNCDS, NNCSS, CNE, MCSE
www.cconlinelabs.com
Your #1 choice for online Cisco rack rentals.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of IMAM
Sent: Thursday, September 23, 2004 11:27 PM
To: 'Tony Schaffran'; ccielab@groupstudy.com
Subject: RE: ip ospf net point to point
By "Network "command
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Tony Schaffran
Sent: Friday, September 24, 2004 11:05 AM
To: 'IMAM'; ccielab@groupstudy.com
Subject: RE: ip ospf net point to point
How are you advertising your loopback address into OSPF?
Tony Schaffran
Network Analyst
CCIE #11071
CCNP, CCNA, CCDA,
NNCDS, NNCSS, CNE, MCSE
www.cconlinelabs.com
Your #1 choice for online Cisco rack rentals.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
IMAM
Sent: Thursday, September 23, 2004 8:29 PM
To: ccielab@groupstudy.com
Subject: ip ospf net point to point
Dear groups
I had configured interface looback.. and advertised this into ospf
routing process.. and I want advertise this to be 24 bit so I have to do
configure ip ospf network point to point under int loopback. but
unfortunately after clear ip routing process *. the route for int loop
not appear in routing table.... what happen . any suggestion ? or this
ones are bugs
IMAM
This archive was generated by hypermail 2.1.4 : Fri Oct 01 2004 - 15:00:48 GMT-3