From: gladston@br.ibm.com
Date: Mon Sep 20 2004 - 11:58:32 GMT-3
=======
quoted
** PVC - Dialer Profiles **
int atm2/0
no ip address
pvc 1/44
encap aal5snap
protocol ppp dialer
dialer pool-member 1
interface dialer1
ip address 10.1.1.1 255.255.255.0
encap ppp
dialer pool 1
=======
Joe,
Have you tested these configuration. I tried it but it is not working. Version is 12.2(23)
ATM#sh run
interface ATM0
pvc 0/108
protocol ppp dialer
dialer pool-member 8
!
interface Dialer8
ip address 172.16.108.10 255.255.255.0
encapsulation ppp
dialer pool 8
R8#sh run
interface ATM6/0/0
pvc 0/108
protocol ppp dialer
dialer pool-member 8
!
!
interface Dialer8
ip address 172.16.108.8 255.255.255.0
encapsulation ppp
dialer pool 8
swr1#sh atm vc
VCD / Peak Avg/Min Burst
Interface Name VPI VCI Type Encaps SC Kbps Kbps Cells Sts
6/0/0 2 0 5 PVC SAAL UBR 155000 UP
6/0/0 1 0 16 PVC ILMI UBR 155000 UP
6/0/0 4 0 108 PVC SNAP UBR 155000 UP
swr1#p 172.16.108.10
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 172.16.108.10, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)
I already tested it without using the PPP configuration, just to check the ATM switch stuff, and it is working fine.
Do you have an URL that explain these configurations?
This archive was generated by hypermail 2.1.4 : Fri Oct 01 2004 - 15:00:46 GMT-3