From: Tom Young (gitsyoung@yahoo.co.jp)
Date: Tue Aug 31 2004 - 00:22:33 GMT-3
NO, I don't means the IOS file, I means the config file
such as runnning-config.
Normally, the config file ( start-config) was read from
NVRAM when the router boot. But I want to save it into
flash and boot it from flash every time when the router
startup.
Thanks alot
--- "Jonathan R. Charles" <jrcdehc@ameritech.net> $B$+$i$N(B
$B%a%C%;!<%8!'(B
> I don't understand... Are you trying to boot a
> specific IOS from flash, if
> so a 'boot system flash <filename>' will work.
>
> If you are trying to load a config from flash, then
> you just need to make
> sure your config-register is set to 0x102 (or
> 0x2102).
>
> Also, you may want to add a 'no service config' to
> prevent the router from
> trying to grab a config from a TFTP server.
>
> These commands are pretty much in every IOS release
> (that I am aware of).
>
>
>
>
> Jonathan
>
> -----Original Message-----
> From: nobody@groupstudy.com
> [mailto:nobody@groupstudy.com] On Behalf Of Tom
> Young
> Sent: Monday, August 30, 2004 21:51
> To: ccielab@groupstudy.com
> Subject: boot config from flash
>
> hi, group
>
> A question about boot config image , I want to
> save the
> config file into flash and boot it from flash
> everytime
> when the router startup. My router is Cisco813, how
> to do
> that ? And what is the min IOS image for it ?
>
> Thanks alot
>
> __________________________________________________
> GANBARE! NIPPON!
> Yahoo! JAPAN JOC OFFICIAL INTERNET PORTAL SITE
> http://mail.ganbare-nippon.yahoo.co.jp/
>
>
This archive was generated by hypermail 2.1.4 : Fri Sep 03 2004 - 07:02:50 GMT-3