From: Scott Morris (swm@emanon.com)
Date: Sun Aug 22 2004 - 16:37:50 GMT-3
One side will have to be FXS. FXO ports assume that the dialtone will be
provided. FXS ports will provide dial-tone/signaling.
Simulating a permanent connection, you must support devices that talk
similar. Thus E&M to E&M (same type), FXO to FXS or FXS to FXS (with no
signaling).
HTH,
Scott Morris, CCIE4 (R&S/ISP-Dial/Security/Service Provider) #4713, CISSP,
JNCIP, et al.
IPExpert CCIE Program Manager
IPExpert Sr. Technical Instructor
swm@emanon.com/smorris@ipexpert.net
http://www.ipexpert.net
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Ali
Fahmi
Sent: Sunday, August 22, 2004 1:36 PM
To: ccielab@groupstudy.com
Subject: PBX to PBX with FXO
Hi All,
Is there any issue to interconnect PABX via IP with FXO interface ?
as far as I know, Connection trunk command doesnt FXO to FXO connection.
Is it possible just creating dial-peer commands without "connection trunk"
command?
thanks,
rgds,
Ali
============================================================================
===============
"Gabung INSTANIA, dapatkan XENIA. Daftar di www.telkomnetinstan.com,
langsung dapat akses Internet Gratis..
Dan ..ikuti "Instan Smile" berhadiah Xenia,Tour S'pore, Komputer,dll, info
hub : TELKOM Jatim 0-800-1-467826 "
============================================================================
===============
This archive was generated by hypermail 2.1.4 : Fri Sep 03 2004 - 07:02:47 GMT-3