From: Swaroop Potdar (swarooppotdar@hotmail.com)
Date: Wed Aug 18 2004 - 14:47:27 GMT-3
Hi Kas,
Thanks...
Swaroop.
>From: "kasturi cisco" <kasturi_cisco@hotmail.com>
>Reply-To: "kasturi cisco" <kasturi_cisco@hotmail.com>
>To: swarooppotdar@hotmail.com, ccie2be@nyc.rr.com,
>richard.dumoulin@vanco.es, gitsyoung@yahoo.co.jp, ccielab@groupstudy.com
>Subject: Re: switchport mode access command
>Date: Wed, 18 Aug 2004 14:49:20 +0000
>
>Hi,
>
>Yes there a couple of things to watch out for when doing this -
>
>One dont over do any cmd and give excess cmds as it wont fetch u
>anything.Also ensure ur doing something for all ports by default wont
>hurt u later (without ur knowledge).
>
>Two, ensure u do what is required by the Q.Re read the Q.If for example
>the Q says in an example - configure the port to be a access port at all
>times ...then such a cmd will help. this will ensure that the port is a
>Access port and wont dynamically switch to a trunk port.
>
>Good Luck,
>Kasturi.
>
>------------------------------------------------------------------------
>
>Sell what you dont Need. Click Here!
>
>_______________________________________________________________________
>Please help support GroupStudy by purchasing your study materials from:
>http://shop.groupstudy.com
>
>Subscription information may be found at:
>http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Sep 03 2004 - 07:02:45 GMT-3