From: Larry Metzger (larrymetzger@sbcglobal.net)
Date: Wed Aug 11 2004 - 02:21:06 GMT-3
I don't see an interface-dlci or frame-relay map. You need one or the
other. It is OSPF multipoint, so I assume you have multiple
connections. Use the frame-relay map and set the dlci.
Larry
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
marc van hoof
Sent: Tuesday, August 10, 2004 10:15 PM
To: ccielab@groupstudy.com
Subject: frame-relay encapsulation
I'm getting these messages:
*Mar 1 15:26:57.760: Serial0/0:Encaps failed--no map entry link 7(IP).
From a debug frame-relay packet command when I try and ping a host
across a
frame-relay cloud.
Here's the interface config:
!
interface Serial0/0
ip address 132.2.0.4 255.255.255.0
encapsulation frame-relay
ip ospf network point-to-multipoint
frame-relay lmi-type cisco
end
and a show interface:
Serial0/0 is up, line protocol is up
Hardware is QUICC Serial
Internet address is 132.2.0.4/24
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation FRAME-RELAY, loopback not set
Keepalive set (10 sec)
LMI enq sent 5521, LMI stat recvd 5522, LMI upd recvd 0, DTE LMI up
LMI enq recvd 0, LMI stat sent 0, LMI upd sent 0
LMI DLCI 1023 LMI type is CISCO frame relay DTE
FR SVC disabled, LAPF state down
Broadcast queue 0/64, broadcasts sent/dropped 11459/0, interface
broadcasts 2868
Last input 00:00:07, output 00:00:07, output hang never
Last clearing of "show interface" counters 15:28:12
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/2/256 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 1158 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
16979 packets input, 3912870 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
1 input errors, 0 CRC, 1 frame, 0 overrun, 0 ignored, 0 abort
16983 packets output, 3876201 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
DCD=up DSR=up DTR=up RTS=up CTS=up
Any ideas ?
This archive was generated by hypermail 2.1.4 : Fri Sep 03 2004 - 07:02:41 GMT-3