From: marc van hoof (mvh@marcvanhoof.com)
Date: Sat Aug 07 2004 - 05:38:16 GMT-3
Read: http://www.cisco.com/warp/public/105/gre_flap.html
Basically, it's all about recursive routing loops when you run a routing
protocol that injects host routes over a tunnel.
The path to the tunnel destination IP is shown as via the tunnel, which is
impossible.
The suggested remedy in this doc is to use a static route to the tunnel
destination, but in the ccie lab we're not allowed to use static routes.
Will a distribute-list solve this problem ? how do I stop eigrp from
advertising a host route, or stop a recipient from putting it into the
routing table.
Regards,
-marc.
This archive was generated by hypermail 2.1.4 : Fri Sep 03 2004 - 07:02:34 GMT-3