From: Sergio Jimenez Arguedas (sejimenez@its.co.cr)
Date: Fri Aug 06 2004 - 19:11:52 GMT-3
Hi,
You can use the cmd "clear frame-relay inarp", If It doesn?t erase the
entries 0.0.0.0,,,
So you to reset the router, It doesn?t matter the IOS you have!!!
Rgds,
Sergio Jimenez Arguedas
CCNA,CCNP,CCIE R&S#13732
ITServicios Infocomunicacion
Tel:(506)2211-0500
-----Mensaje original-----
De: nobody@groupstudy.com [mailto:nobody@groupstudy.com]En nombre de
ccie2be
Enviado el: viernes, 06 de agosto de 2004 16:00
Para: Group Study
Asunto: No fram inverse - Not working
Hi guys,
Here's my config:
interface Serial1/0
no ip address
encapsulation frame-relay
no frame-relay inverse-arp
!
interface Serial1/0.302 point-to-point
ip address 148.6.0.3 255.255.255.0
frame-relay interface-dlci 302
***********************************************
Before I configured encap frame-relay, I had shut down the interface. Then I
configured the above.
After I re-enabled the interface, here's what I got:
Rack1R3#sh fram map
Serial1/0 (up): ip 0.0.0.0 dlci 305(0x131,0x4C10)
broadcast,
CISCO, status defined, inactive
Serial1/0 (up): ip 0.0.0.0 dlci 304(0x130,0x4C00)
broadcast,
CISCO, status defined, active
Serial1/0 (up): ip 0.0.0.0 dlci 301(0x12D,0x48D0)
broadcast,
CISCO, status defined, active
Serial1/0.302 (up): point-to-point dlci, dlci 302(0x12E,0x48E0), broadcast
status defined, active
Why is this happening and what can I do to prevent this from happening?
After I reload the router, those mappings to 0.0.0.0 are gone, but I hate to
have to reload the router to get rid of them.
Might this have something to do with the release of IOS I'm using?
The release is:
Rack1R3#sh ver
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-J1S3-M), Version 12.2(15)T5, RELEASE
SOFTWARE
(f
c1)
Thanks for any feedback, Tim
This archive was generated by hypermail 2.1.4 : Fri Sep 03 2004 - 07:02:34 GMT-3