From: Ronnie Higginbotham (ronniepaul@hotmail.com)
Date: Wed Aug 04 2004 - 19:47:36 GMT-3
Richard,
It is more a matter of your preference. If you are comfortable with qos
then do manual. Manual qos you have more control over your traffic. AUTO qos
will adjust these needed settings for you.
However you have your syntax wrong on the Auto qos setup. You only need to
enable auto qos under the interface it will enable mls global and change all
the variables for you.
Take a look at the QOS document. You cannot run both modes it is one or the
other.
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12220se/3750scg/swqos.htm#wp1231112
Ronnie
----- Original Message -----
From: "Richard Anderson" <richard.p.anderson@sbcglobal.net>
To: <ccielab@groupstudy.com>
Sent: Wednesday, August 04, 2004 2:46 PM
Subject: Auto QOS
> Folks,
>
> What is the recommendation for QOS when Cisco 3750 switches are supporting
> both Data and Voice for IP Phones?
>
> All Switches:
>
> Manual Configuration:
> ---------------------------------------------
> Global Configuration:
> MLS QOS
>
> Interface Configuration:
> MLS QOS TRUST COS
>
> --------------------------------------------------------------------------
--- > --------------------------------------------------- > > AutoQOS > ------------------------------------------------ > > Global Configuration: > MLS QOS > > Interface Configuration > MLS QOS TRUST DEVICE CISCO-PHONE > MLS QOS TRUST COS > AUTO QOS VOIP CISCO-PHONE > > _______________________________________________________________________ > Please help support GroupStudy by purchasing your study materials from: > http://shop.groupstudy.com > > Subscription information may be found at: > http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Sep 03 2004 - 07:02:33 GMT-3