From: Dan Shechter (danshtr@yahoo.com)
Date: Tue Jul 20 2004 - 11:23:25 GMT-3
AFAIK there is no diff between:
1. dialer load-threshold
2. ppp multilink load-threshold
3. multilink load-threshold
am i right?
Noble T N wrote:
>Hello:
>
>I think this command has not got anything to do with the initial connection
>initiation. As u say it can sometimes cause some confusion if the same is
>configured both the ends. To configure bandwidth on demand by setting the
>maximum load before the dialer places another call to a destination, use the
>dialer load-threshold command in interface configuration mode.
>
>
>Regards,
>
>Noble
>
>
>-----Original Message-----
>From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
>Dan Shechter
>Sent: 20 July 2004 16:31
>To: Group Study
>Subject: Multilink - who should dial?
>
>
>Hello all,
>
>I have read somewhere that the 'dialer load-threshold' should be
>configured only on one end, because both side might initiate the
>connection in the same time and the call won't succeed.
>
>Is it right?
>
>_______________________________________________________________________
>Please help support GroupStudy by purchasing your study materials from:
>http://shop.groupstudy.com
>
>Subscription information may be found at:
>http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sun Aug 01 2004 - 10:11:59 GMT-3