From: Jason Aarons (jaarons@hotmail.com)
Date: Sat Jul 17 2004 - 11:42:06 GMT-3
Can I configure frame-relay on the 1 Channelized T1/PRI port ? The
circuit isn't a PRI but CAS. I am thinking I ordered the wrong hardware
to put a serial0 in for the frame relay. I don't see in show ip int brief
a serial interface....how come? It has been a long time since I setup a
frame interface, I am thinking I am missing something simple...
router-c3745-bgp#show ver
Cisco Internetwork Operating System Software
IOS (tm) 3700 Software (C3745-IS-M), Version 12.3(5b), RELEASE SOFTWARE
(fc1)
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Thu 15-Jan-04 23:39 by kellythw
Image text-base: 0x60008AF4, data-base: 0x61B62000ROM: System Bootstrap,
Version 12.2(8r)T2, RELEASE SOFTWARE (fc1)router-c3745-bgp uptime is 6
days, 23 hours, 38 minutes
System returned to ROM by power-on
System image file is "flash:c3745-is-mz.123-5b.bin"cisco 3745 (R7000)
processor (revision 2.0) with 249856K/12288K bytes of memory.
Processor board ID JMX0814L0E3
R7000 CPU at 350MHz, Implementation 39, Rev 3.3, 256KB L2, 2048KB L3
Cache
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
Primary Rate ISDN software, Version 1.1.
2 FastEthernet/IEEE 802.3 interface(s)
1 Channelized T1/PRI port(s)
DRAM configuration is 64 bits wide with parity disabled.
151K bytes of non-volatile configuration memory.
62592K bytes of ATA System CompactFlash (Read/Write)Configuration
register is 0x2102router-c3745-bgp#show run
Building configuration...
version 12.3
!
controller T1 0/0
framing esf
crc-threshold 320
linecode b8zs
!
interface FastEthernet0/0
description ISP
ip address 150.216.50.1 255.255.255.0
!
ip route 0.0.0.0 0.0.0.0 FastEthernet0/0
end
------------------------------------------------------------------------
FREE pop-up blocking with the new MSN Toolbar get it now!
This archive was generated by hypermail 2.1.4 : Sun Aug 01 2004 - 10:11:57 GMT-3