From: Tony Schaffran (groupstudy@cconlinelabs.com)
Date: Wed Jul 07 2004 - 20:08:34 GMT-3
I believe you need a T1 cross-over cable.
1,2,4, and 5
Tony Schaffran
Network Analyst
CCIE #11071
CCNP, CCNA, CCDA,
NNCDS, NNCSS, CNE, MCSE
www.cconlinelabs.com
Your #1 choice for online Cisco rack rentals.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Jose
Mujica
Sent: Wednesday, July 07, 2004 12:47 PM
To: ccielab@groupstudy.com
Subject: ATM Back-to-Back Config
HI.
I have two 2600 routers each with an NM-1ATM-25 atm card. I would like to
do
a back-to-back configuration but the interface still down, down. I look at
CCO
sample configs and I'm using exactly the same configuration without any
luck.
I'm using 12.2(15)T12 on both routers... Here the configuration I'm using:
R1:
interface ATM1/0
ip address 192.168.1.20 255.255.255.0
map-group atm-in
atm clock INTERNAL
atm pvc 1 1 5 aal5snap
atm ilmi-keepalive
no atm address-registration
!
map-list atm-in
ip 192.168.1.10 atm-vc 1 broadcast
!
R2:
interface ATM1/0
ip address 192.168.1.10 255.255.255.0
map-group atm-in
atm clock INTERNAL
atm pvc 1 1 5 aal5snap
atm ilmi-keepalive
!
map-list atm-in
ip 192.168.1.20 atm-vc 1 broadcast
!
I tried with standard ethernet cables (i.e. straight and cross cables)..
Am I missing something else?
Thanks in advanced,
-Jose
This archive was generated by hypermail 2.1.4 : Sun Aug 01 2004 - 10:11:48 GMT-3