From: Asep Ruhimat (asep.ruhimat@asaba.co.id)
Date: Tue Jul 06 2004 - 07:17:06 GMT-3
Hi oliver,
It was 3 years ago, Correct me if wrong
1. Find out the menu "VLan Port Configuration.."
2. Fill in the Menu "Port:" exs:25, "PVID:" exs:10, "port name":Port 25, "Tagging":Tagging trunk.
3. repeat the step if select another port (Create Multilink Trunk)
4. On the menu, pls select "Multilink Trunk Configuration..." (Multilink trunk Configured)
5. Select Trunk 1, Trunk Member: exs Port 24 and port 25, STP learning: Normal, Trunk mode: basic, Trunk Status: Enabled.
Good Luck,
/immat
#12383
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Oliver Ziltener
Sent: Tuesday, July 06, 2004 3:58 PM
To: ccielab@groupstudy.com
Subject: OT: Trunking dot1Q between catalyst and Bay 350T
Hello
has somebody experience with trunking (dot1q) between IOS catalyst
switches and a Bay Networks 350T Switch.
I tried yesterday but it didn't work. How i could set up trunking on the
Bay Switch?
any help is very welcome
best regards
Oliver
This archive was generated by hypermail 2.1.4 : Sun Aug 01 2004 - 10:11:47 GMT-3