From: Brian Dennis (bdennis@internetworkexpert.com)
Date: Wed Jun 30 2004 - 20:38:55 GMT-3
Ronnie,
Are you thinking of:
dialer watch-list <group-number> delay route-check initial <time>
Time, in seconds, after which the router ensures that the primary route
is up once initial startup is complete.
Here is the output from the help on the router:
Rack1R3(config)#dialer watch-list 1 delay ?
connect Interval before dialing the secondary route
disconnect Interval before disconnecting the secondary route
route-check Interval for checking watched route
Rack1R3(config)#dialer watch-list 1 delay route-check ?
initial Delay for initial check of watched route after boot
Brian Dennis, CCIE #2210 (R&S/ISP-Dial/Security)
bdennis@internetworkexpert.com
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-224-8987
Direct: 775-745-6404 (Outside the US and Canada)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Ronnie Higginbotham
Sent: Wednesday, June 30, 2004 4:26 PM
To: ccielab@groupstudy.com
Subject: Re: Dialer Watch
> I don't think they are the same.
>
> dialer watch-disable <seconds> (Disconnects the line once the watched
route
> has been up and stable for set number of seconds)
>
> dialer watch-list 1 delay disconnect <seconds> (Once router is
rebooted
this
> command will delay dialer watch from beginning to watch the route in
order
> to give the frame circuit for example time to come up.) This command
only
> applies to bootup.
>
> Ronnie
>
>
> ----- Original Message -----
> From: "Brian Dennis" <bdennis@internetworkexpert.com>
> To: "ccie2be" <ccie2be@nyc.rr.com>; "Group Study"
<ccielab@groupstudy.com>
> Sent: Wednesday, June 30, 2004 3:36 PM
> Subject: RE: Dialer Watch
>
>
> > Tim,
> > They are the same. The watch-disable command is depreciated.
> >
> > Brian Dennis, CCIE #2210 (R&S/ISP-Dial/Security)
> > bdennis@internetworkexpert.com
> > Internetwork Expert, Inc.
> > http://www.InternetworkExpert.com
> > Toll Free: 877-224-8987
> > Direct: 775-745-6404 (Outside the US and Canada)
> >
> >
> > -----Original Message-----
> > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
Of
> > ccie2be
> > Sent: Wednesday, June 30, 2004 1:10 PM
> > To: Group Study
> > Subject: Dialer Watch
> >
> > Hi guys,
> >
> > What's the difference between
> >
> > dialer watch-disable <seconds>
> >
> > and
> >
> > dialer watch-list 1 delay disconnect <seconds>
> >
> > They seem to do the same thing. Are they interchangable?
> >
> > TIA, Tim
> >
> >
This archive was generated by hypermail 2.1.4 : Sat Jul 03 2004 - 19:40:53 GMT-3