From: Brian Dennis (bdennis@internetworkexpert.com)
Date: Wed Jun 30 2004 - 16:10:21 GMT-3
Joseph,
Can you send the output of a "show ip route" along with your BGP
configuration? Also I'm curious as to why you did do step 3. Were you
trying to filter off other routes?
Brian Dennis, CCIE #2210 (R&S/ISP-Dial/Security)
bdennis@internetworkexpert.com
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-224-8987
Direct: 775-745-6404 (Outside the US and Canada)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Joseph D. Phillips
Sent: Wednesday, June 30, 2004 11:44 AM
To: group study
Subject: RE: Redistribution of routes into BGP without using aggregation
or redistribute command]
Yes, I did all of that. I tried:
1. Doing a show ip route isis to get the routes
2. I specified the routes with the network command under bgp
3. I created a prefix list for all the routes and matched a route-map to
it, and specified the route-map in a neighbor statement so I could
advertise the routes to the neighbor
The ISIS routes I am supposed to advertise are all L1's.
-------- Original Message --------
Subject: RE: Redistribution of routes into BGP without using
aggregation or redistribute command
Date: Wed, 30 Jun 2004 14:12:02 -0400
From: Brian Dennis <bdennis@internetworkexpert.com>
To: Joseph D. Phillips <josephdphillips@fastmail.us>, group study
<ccielab@groupstudy.com>
Joseph,
Did you try using the network statement?
Brian Dennis, CCIE #2210 (R&S/ISP-Dial/Security)
bdennis@internetworkexpert.com
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-224-8987
Direct: 775-745-6404 (Outside the US and Canada)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Joseph D. Phillips
Sent: Wednesday, June 30, 2004 11:03 AM
To: group study
Subject: Redistribution of routes into BGP without using aggregation or
redistribute command
I have a requirement to get ISIS-learned routes into the BGP tables of
BGP neighbors without using redistribution or aggregation commands. I'm
stumped.
I tried advertising the routes as backdoors but that didn't work.
I specified the prefixes in a prefix list and referenced by a route-map
and applied the route-map to the neighbor command and that didn't work.
Any ideas?
This archive was generated by hypermail 2.1.4 : Sat Jul 03 2004 - 19:40:53 GMT-3