From: Xiangrong Wang (xiangrow@cisco.com)
Date: Mon Jun 28 2004 - 23:38:20 GMT-3
Hi Geert,
In 12.2T and above, you can use "show ip eigrp interfaces detail" to verify
the eigrp hello interval and authentication mode on an interface. (see the
sample output below) But for 12.2M, the command is not available.
HTH,
Xiangrong
Router#show ip eigrp interfaces detail
IP-EIGRP interfaces for process 100
Xmit Queue Mean Pacing Time Multicast Pending
Interface Peers Un/Reliable SRTT Un/Reliable Flow Timer Routes
Et0/0 0 0/0 0 0/10 0 0
Hello interval is 5 sec
Next xmit serial <none>
Un/reliable mcasts: 0/0 Un/reliable ucasts: 0/0
Mcast exceptions: 0 CR packets: 0 ACKs suppressed: 0
Retransmissions sent: 0 Out-of-sequence rcvd: 0
Authentication mode is md5, key-chain is "test"
At 12:32 AM 06/29/04 +0200, Geert Nijs wrote:
>Hi all,
>
>Just two simple questions, which i just can't seem to find:
>
>- How can you verify the EIGRP timers ?? How can i check the interval of
>my hello packets on an interface ?
> Is there a show command for this or do i really have to do a
>debug (or know it by heart).
> I am looking for a way to see the hello timings on an interface
>(like when you do: show ip prot, for rip you can see: sending rip
>updates every xx seconds,
> ospf has his hello and dead timers listed in "show ip
>ospf int"...and EIGRP ???)
>
>
>- How can i verify if EIGRP is using my authentication keys ?? (with
>ospf, you can do a "show ip ospf int", and the last line reads: "Message
>Digest authentication
> enabled"). Is there something like this for EIGRP also ??
>
>
>
>Regards,
>Geert
This archive was generated by hypermail 2.1.4 : Sat Jul 03 2004 - 19:40:52 GMT-3