From: MMoniz (ccie2002@tampabay.rr.com)
Date: Fri Jun 25 2004 - 20:26:16 GMT-3
I believe you can accomplish this by adjusting the ospf distance for the
specific nets
received on the hub router. (depending on how you are set up)
IE Voice net AD 115 Data 110, vice versa on the other circuit. Since this is
a remote spoke
you shouldn't have to worry about this influencing other rtr's.
This is assuming the spoke rtr is the rtr puting these nets into OSPF.
Mike
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Nir Wittenberg
Sent: Friday, June 25, 2004 7:06 PM
To: ccielab@groupstudy.com
Subject: policy routing via OSPF
I have a HQ site with two routers and a remote site with one Frame Relay
T1 with a pvc connection to each HQ router. All are in the same OSPF
area. I want data to travel over one pvc and voice to travel on the
other. Voice and data are on separate networks. How can I use ospf to
route the traffic over the correct pvc and then failover to the other in
case of failure.
Need a little refresher.
Nir
CCIE 12261
_______ voice and
data vlans______
|
|
HQ1
HQ2
\
/
\
/
\
/
\
/
\
/
\
/
\
/
\
/
R1
|
_______ voice and data
vlans______
This archive was generated by hypermail 2.1.4 : Sat Jul 03 2004 - 19:40:50 GMT-3