From: Lee Donald (Lee.Donald@bacs.co.uk)
Date: Thu Jun 24 2004 - 10:21:58 GMT-3
Has anyone done the above IE Lab, which involves a BGP Peering between R6 and BB1.
The previous section on this was to configure NAT to allow reachablity from the inside to BB1 because of a lack of routing on BB1. Basically the NAT allowed BB1 to see all the traffic coming from R6, and it knew how to reach R6 and hence, full reachablity.
But now I've configured a peering between R6 and BB1 which never comes up because of the port translation associated with the NAT. I removed ip nat outside off the ATM interface towards BB1, and the peering comes up.
I need to configure a static entry for the BGP peering so that Nat doesn't change this address/port.
Does anyone know the correct syntax ?
-----------------------------------------------------
You can find us at www.bacslimited.co.uk
*****************************************************
This communication is confidential and intended for
the exclusive use of the addressee only. You should
not disclose its contents to any other person.
If you are not the intended recipient please notify
the sender named above immediately.
BACS Limited, registered in England, No 1023742,
Drake House, Three Rivers Court, Homestead Road,
Rickmansworth, WD3 1FX
*****************************************************
This archive was generated by hypermail 2.1.4 : Sat Jul 03 2004 - 19:40:49 GMT-3