From: Koen Peetermans (K.Peetermans@chello.be)
Date: Wed Jun 16 2004 - 13:20:56 GMT-3
Probably a stupid question, but since I've never worked with an IP-Phone
might as well ask it :
Are all these commands executed on the catalyst switch ? I find it rather
strange that the "phone overrides pc traffic" with a command executed on the
catalyst switch. Is this right, does the phone "know" what to do with COS
because of the command on the catalyst, or does the catalyst does this job
and not the phone ?
Koen.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Richard Dumoulin
Sent: woensdag 16 juni 2004 17:59
To: Tom Young; ccielab@groupstudy.com
Subject: RE: Voice vlan setting
Do you want the pc attached to the phone to be trsuted by the phone ? If yes
then you need "switchport priority extend trust". Then the switch will trust
both the voice and the pc thx to "mls qos trust cos".
If not then just "mls qos trust cos" as the phone will override pc traffic
to COS 0,
--Richard
-----Original Message-----
From: Tom Young [mailto:gitsyoung@yahoo.co.jp]
Sent: miircoles, 16 de junio de 2004 17:08
To: ccielab@groupstudy.com
Subject: Voice vlan setting
Hi, group
Look the two commands below for setting voice vlan. If I
want to trust a VoIP telephone setting, should I need set
the two command on the voice vlan interface ?
switchport priority extend trust
mls qos trust cos
Thanks alot
This archive was generated by hypermail 2.1.4 : Sat Jul 03 2004 - 19:40:41 GMT-3